Commands Menu; Gas Valves Menu; Set Sequences Menu - Edwards GXS Series Instruction Manual

9.4.4 Commands menu

Under the Setup menu. Scroll by pressing the UP/DOWN keys. Press ENTER to open a
sub menu or CANCEL to exit back to the Setup menu. A security code is needed to enter
the commands menus: 202.
Table 32 Commands menu
Commands menu
Inlet Isolation Valve (Open/Shut)
MB Pump (On/Off)*
Green Mode
Green Level
Solvent Soak
DP Clean
Gas Valves
PID Autotune
PID (On/Off)
2nd DP Speed
2nd MB Speed
Force control
Test Mode (On/Off)
* The PDT must be in control to perform these functions.
Press the UP/DOWN keys to select the new settings and press ENTER to accept or
CANCEL to exit back to the Commands menu.

9.4.5 Gas valves menu

Scroll by pressing the UP/DOWN keys. Press ENTER to open a sub menu or CANCEL to
exit back to the Setup menu. Settings do not appear if they are not fitted.
Table 33 Gas valves menu
Gas valves menu
Set N
2
Set Gas Ballast
Set Inlet
Press the UP/DOWN keys to select on/off and press ENTER to accept or CANCEL to exit
back to the Gas valves menu.

9.4.6 Set sequences menu

Under the Setup menu. Scroll by pressing the UP/DOWN keys. Press ENTER to open a
sub menu or CANCEL to exit back to the Setup menu. A security code is needed to enter
the set sequences menus: 202.
M58800880_H - Pump display terminal
Seal
Page 124