Fault Finding; Pdt Events; Led Event Indicators; Pdt Event Messages - Edwards GXS Series Instruction Manual

Dry screw vacuum pump
Table of Contents

Advertisement

10. Fault finding

10.1 PDT events

There are some circumstances in which the system is unable to respond to a command
that has been made. To help in understanding why an operation was not possible, the
pump triggers an event and displays a message on the PDT (if fitted).

10.1.1 LED event indicators

When a new event is triggered, the warning LED on the PDT will flash. To acknowledge
an event, press ENTER on the PDT. Once the event has been acknowledged the warning
LED on the PDT will return to its previous state.
Note:
The events are only indicated by the PDT warning LED. The pump LEDs do not indicate
events.

10.1.2 PDT event messages

When a new event is triggered an event message appears on the PDT. Refer to
Events
for a list of event messages that might be displayed on the PDT with possible
causes and actions that should be taken.
Once an event has been acknowledged, the event message clears from the PDT.
Table 54 Events
Event message on PDT
Event 11.41
on page 160
Event 11.42
on page 161
Event 11.45
on page 161
Event 317.43
on page 161
Event 317.46
on page 161
Event 317.47
on page 161
Event 322.22
on page 161
Event 331.42
on page 162
Event 331.43
on page 162
Event 331.46
on page 162
Fault
Event 11.41
Cannot go on-process. The pump has an active warning.
Cause
The pump has an active warning.
Remedy
Either clear the source of the warning or enable the pump to go on‑process with a
warning (refer to
M58800880_H - Fault finding
Possible cause
Cannot go on‑process. The pump has an active warning.
Warming up the pump before going on-process.
Cannot go on-process. The pump has an active interlock.
Can not start Command. The pump is not in the green mode.
Cannot start Command. The pump is not running.
Cannot start Command. Already running on the pump.
Cannot start Command. The pump is not stopped.
Cannot start Command. The pump is not warmed up.
Cannot start Command. The pump is not in the green mode.
Cannot start Command. The pump is not running.
Allow a pump to go on-process with a warning
Page 160
Table:
on page 137).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents