How To Configure The Pump Warm-Up Options; Figure 58 Warm-Up Pdt Menu Items - Edwards GXS Series Instruction Manual

M58800880_H - Pump display terminal

9.6 How to configure the pump warm-up options

By default the pump performs an intelligent warm‑up cycle to a temperature setpoint so
that the pump is warm before it is allowed to be on‑process. Once the pump reaches the
temperature set point it automatically goes on‑process.
If the pump is no longer to be on‑process, a choice can be made to either stop the pump
or put it into the green mode/standby mode.
If the pump is in the Green mode/standby mode it can either be put on‑process or
stopped.
It is possible to change the behaviour of the pump using the PDT. The following menus
are used by the PDT to configure warm‑up.

Figure 58 Warm-up PDT menu items

Page 135