Mechanical Data; Connection Technology; Table 7 Mechanical Data; Table 8 Connection Technology - WAGO 765-1205/100-000 Product Manual

Properties

4.4.2 Mechanical Data

Property
Width
Height
Length
Weight
Housing
Mounting type
Tightening torque
Mounting holes

4.4.3 Connection Technology

Property
Power Connection
EtherCAT Connection
Digital inputs/outputs
Tightening Torque
Digital Input/Output, 1L or 2L Powered
Property
Digital Input
Characteristic
Parameter
Recording cycle
Circuit
Indicators
Digital Output
Output voltage
Current
Residual current
Circuit
18 Product manual | Version: 2.0.0
8DIO FLD EC DC 24V 2.0A
Table 7: Mechanical Data
Value
35 mm
30 mm
210 mm
368.9 g
Zinc Die Casting
Screw mount, 2 × M4
M4: 1.2 Nm
Diameter: 4.5 mm
Distance from each: 198.0 mm ± 0.2 mm
Table 8: Connection technology
Value
PWR IN: M12 L-coded, 5-pin, plug
PWR OUT: M12 L-coded, 5-pin, socket
2 × M12, D-coded, socket, 4-pin
8 × M8, A-coded, socket, 3-pin
M12: 1.0 Nm
Table 9: Digital Input/Output, 1L or 2L Powered
Value Value (per UL)
Type 3 (IEC 61131-2)
Digital software input filter: without, 3 ms, 15 ms,
20 ms
The input signal change must be at most 2.5 kHz for
correct device-internal detection of changes. However,
note that the transfer and processing of the process
data (in the device and controller) also take time and
reduce the maximum input signal change.
200 μs
The digital input is not resistant to feedback.
The input voltage must not exceed the supply voltage.
On/off status LED
24 VDC
Port X01 to X04: 1L powered
Port X05 to X08: 2L powered
Normal operation: max. 2.0 A per channel
Overload operation: max. 2.4 A per channel, per
IEC 61131-2
Less than 1 mA
High-side driver
The digital output is not resistant to feedback.
The input voltage must not exceed the supply voltage.
765-1205/100-000