Snmp - Tripp Lite NetCommander B070-016-19-IP Owner's Manual

17. SNMP

From this page you can activate or deactivate SNMP logging.
Enable traps: Check to enable SNMP traps of KVM Access events and operation.
Community: Type the SNMP community
SNMP Manager IP: Enter the SNMP Server IP address
The following table lists the events that are recorded and sent via SNMP traps.
Event Text
"System Boot"
"Server Busy ask for disconnect..."
"User login succeeded"
"Login failed wrong user name or password"
"Login not succeeded server busy"
"Logout"
"Disconnected by another user"
"Hardware failure"
"Hard reset power cycle command"
"Viewer login"
"Viewer logout"
"Global access disabled"
"Block User Account"
"Successful User Login"
"Login is not successful – wrong user access level"
"Wrong user name or password"
"Login is not successful because server is busy"
"DHCP server setting has been changed"
"Network IP address changed"
"Network Subnet Mask changed"
"Network Default Gateway changed"
"User Logged out from Config"
"TCP Port was changed"
"Remote Access type was changed"
"Security settings changed"
"Restore default factory settings successful"
"Restore default factory settings failed"
"Firmware Upgrade successful"
"Firmware Upgrade failed"
201204110 93-2924.indd 13
Code Description
1010 Reported upon device boot up.
Reported when a user with take over privileges attempts to login during an active session.
1030
The message is sent before the user chooses whether to take over control of the KVM.
1040 Reported upon every successful user login to the device.
1050 Reported upon a login failure due to a wrong username or password.
Reported when a login is denied because the active session is held by an account with higher
1060
privileges. (Takeover not allowed)
1070 Reported when a user logs out of their remote session.
Reported when a takeover has been successfully performed and the previous user's session
1110
is disconnected.
1200 Reported due to internal device hardware failure. Try disconnecting attached devices and reboot.
Reported when a power cycle command is issued. This is only relevant when a special power
1220
cycle product is attached to the device. (e.g. KBPower)
1230 Reported when a user accesses the KVM in view only mode while an active session is in place.
1240 Reported when a user accessing the KVM in view only mode logs out of their remote session.
Reported when the device has been blocked for access by an administrator. Remote access to
1250
the KVM is disabled until the administrator unblocks it.
1260 Reported when a user is blocked from accessing the KVM due to too many failed login attempts.
2010 Reported when a user successfully logs into the Web Configuration Interface.
Reported when a user is denied access to the Web Configuration Interface because they are
2020
not an administrator and not authorized to access it.
Reported when a user is denied access to the Web Configuration Interface due to an incorrect
2030
username or password.
Reported when a user is denied access to the Web Configuration Interface because an active
2040
session is in place.
2060 Reported when the DHCP server network setting is changed.
2070 Reported when the IP address network setting is changed.
2080 Reported when the Subnet Mask network setting is changed.
2090 Reported when the Default Gateway network setting is changed.
2100 Reported when a user logs out of the Web Configuration Interface.
2110 Reported when the TCP port network setting is changed.
2120 Reported when an account's permission is changed.
2140 Reported when a security setting is changed.
2150 Reported when the factory default settings are successfully restored.
2160 Reported when restoring the factory default settings fails.
2170 Reported when a firmware upgrade succeeds.
2180 Reported when a firmware upgrade fails.
13
8/2/2012 10:15:55 AM