Reverse Warning Buzzer Installation - Club Car Precedent Villager 2 Maintenance And Service Manual

19
Reverse Warning Buzzer
1
A, Red/White wire B. Black wire
711
Figure 19-21 Reverse Buzzer

REVERSE WARNING BUZZER INSTALLATION

1. Install the screws (3) through the buzzer bracket tabs and tighten to 3.5 in·lb (0.40 N·m) (Figure 19-21, Page
19-24).
2. Connect the black wire (1) from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire (4) from the wire harness to the positive (+) terminal on the buzzer.
4. Install the instrument panel.
4.1. Connect the electrical connector (3) (Figure 19-19, Page 19-18).
4.2. Position the instrument panel (2) on the dash assembly. Make sure tabs on upper edge properly engage
with the corresponding slots on the dash assembly. Ensure that there are no wires exposed or pinched
during positioning.
4.3. Secure instrument panel to the dash assembly with three screws (1). Tighten screws to 1.8 ft·lb (2.5 N·m).
5. Connect battery and spark plug wire(s).
See Connecting the Battery- Gasoline Vehicles on page 1-3.
6. Shift the Forward/Reverse handle to the REVERSE position. The buzzer should sound.
Page 19-24 2019 Precedent Villager 2 Maintenance and Service Manual
4
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS