Rear Shock Installation - Club Car Carryall 295 Maintenance And Service Manual
Hide thumbs
Also See for Carryall 295:
- Maintenance and service manual (432 pages) ,
- Owner's manual (72 pages) ,
- Owner's manual (68 pages)
Table of Contents
Advertisement
REAR SUSPENSION
1. Location of brake hose with rubber grommet
2494
Figure 9-5 Rear Shock Absorber Removal
REAR SHOCK INSTALLATION
Ensure that the adjustment position of the coil spring on the new shock absorber is the same as the previous shock
absorber. Use the adjustment position on the coil spring from the previous shock absorbers as a reference. See
following NOTE.
NOTE: When shock absorbers are installed, ensure both shock absorbers have identical part numbers.
1.
Installation is the reverse of removal.
2.
Tighten the upper and lower hardware, using new lock nuts, to 73 ft-lb (99 N·m).
3.
If detached during removal, secure the brake hose and rubber grommet in the lower shock bracket.
4.
Install wheel and lower vehicle. See Wheel Installation on page 8-2.
5.
Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles on page 1-4.
Rear Coil-Over Shock Absorber – Starting 2012 Model Year
1
2008-2012 All-Wheel Drive Maintenance and Service Manual
9
Page 9-5
Advertisement
Table of Contents
Troubleshooting
