Chroma 63200A Series Operation & Programming Manual page 97

High Power Electronic Load 63200A Series Operation & Programming Manual
Return Parameters:<CRD>, OFF(0), ON(1)
Query Example:
[ADVance:]OPP:RESult?
Type:
Description:
Setting Syntax:
Setting Parameters:None
Setting Example:
Query Syntax:
Return Parameters:<arg1>,<arg2>,<arg3>
Query Example:
[ADVance:]CURRent:SWEep:IMAXimum
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
Setting Example:
Query Syntax:
Return Parameters:<NR2>, [Unit = Ampere]
Query Example:
[ADVance:]CURRent:SWEep:IMINimum
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
Setting Example:
Query Syntax:
Return Parameters:<NR2>, [Unit = Ampere]
Query Example:
4-34
OPP:LATC?
Channel-Specific
Returns the result of OPP test function.
None
None
[ADVance:]OPP:RESult?
<arg1>: Pass/Fail. <NR1>, 0: PASS 1: FAIL [Unit = None]
<arg2>: OPP power. <NR2>, [Unit = Watt]
<arg3>: Maximum power. <NR2>, [Unit = Watt]
When the returns are
-1,-1,-1 denotes OPP test is stop.
-2,-2,-2 denotes OPP test is ready to execute what wait for Von
or other condition.
-3,-3,-3 denotes OPP test is execute.
OPP:RES?
Channel-Specific
Set the maximum current for constant current frequency sweep
mode.
[ADVance:]CURRent:SWEep:IMAXimum<space><NRf+>[suffix]
CURR:SWE:IMAX 20
CURR:SWE:IMAX 10A
CURR:SWE:IMAX MAX
CURR:SWE:IMAX MIN
[ADVance:]CURRent:SWEep:IMAXimum?[<space><MAX | MIN>]
CURR:SWE:IMAX?
CURR:SWE:IMAX? MAX
CURR:SWE:IMAX? MIN
Channel-Specific
Set the minimum current for constant current frequency sweep
mode.
[ADVance:]CURRent:SWEep:IMINimum<space><NRf+>[suffix]
CURR:SWE:IMIN 20
CURR:SWE:IMIN 10A
CURR:SWE:IMIN MAX
CURR:SWE:IMAX MIN
[ADVance:]CURRent:SWEep:IMINimum?[<space><MAX | MIN>]
CURR:SWE:IMIN?
CURR:SWE:IMIN? MAX
CURR:SWE:IMIN? MIN
[Unit = None]
Set max current = 20A.
Set max current = 10A.
Set max current = maximum value.
Set max current = minimum value.
Set min current = 20A.
Set min current = 10A.
Set min current = maximum value.
Set min current = minimum value.