Resistance Subsystem - Chroma 63200A Series Operation & Programming Manual

CURRent:DYNamic:VRNG
Type:
Description:
Setting Syntax:
Setting Parameters:<CRD | NR1>, LOW | L | 0, MIDDLE | M | 1, HIGH | H | 2
Setting Example:
Query Syntax:
Return Parameters:<CRD>, LOW(0), MIDDLE(1), HIGH(2)
Query Example:
4.3.2.5

RESISTANCE Subsystem

RESistance:STATic:L1
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
Setting Example:
Query Syntax:
Return Parameters:<NR2>, [Unit = OHM]
Query Example:
RESistance:STATic:L2
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
Setting Example:
Query Syntax:
Return Parameters:<NR2>, [Unit = OHM]
Query Example:
CURR:DYN:FALL? MIN
Channel-Specific
Set the voltage measurement range in CCD mode.
CURRent:DYNamic:VRNG<space><CRD | NR1>
CURR:DYN:VRNG HIGH
CURR:DYN:VRNG M
CURR:DYN:VRNG 0
CURRent: DYNamic: VRNG?
CURR:DYN:VRNG?
Channel-Specific
Set static resistance level for constant resistance mode.
RESistance:STATic:L1<space><NRf+>[suffix]
RES:STAT:L1 20
RES:STAT:L1 10 OHM
RES:STAT:L1 MAX
RES:STAT:L1 MIN
RESistance:STATic:L1?[<space><MAX | MIN>]
RES:STAT:L1?
RES:STAT:L1? MAX
RES:STAT:L1? MIN
Channel-Specific
Set static resistance level for constant resistance mode.
RESistance:STATic:L2<space><NRf+>[suffix]
RES:STAT:L2 20
RES:STAT:L2 10 OHM
RES:STAT:L2 MAX
RES:STAT:L2 MIN
RESistance:STATic:L2?[<space><MAX | MIN>]
RES:STAT:L2?
RES:STAT:L2? MAX
Remote Operation
Set voltage range to High.
Set voltage range to Middle.
Set voltage range to Low.
[Unit = None]
Set constant resistance = 20Ω
for Load L1.
Set constant resistance = 10Ω
for Load L1.
Set constant resistance = maximum
value for Load L1.
Set constant resistance = minimum
value for Load L1.
Set constant resistance = 20Ω
for Load L2.
Set constant resistance = 10Ω
for Load L2.
Set constant resistance = maximum
value for Load L2.
Set constant resistance = minimum
value for Load L2.
4-19