Chroma 63200A Series Operation & Programming Manual page 90

Query Syntax:
Return Parameters:<NR2>, [Unit = Ampere | Ohm | Watt]
Query Example:
[ADVance:]BATTery:RISE
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
Setting Example:
Query Syntax:
Return Parameters:<NR2>, [Unit = A/uS]
Query Example:
[ADVance:]BATTery:FALL
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
Setting Example:
Query Syntax:
Return Parameters:<NR2>, [Unit = A/uS]
Query Example:
[ADVance:]BATTery:ENDVoltage
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
BATT:VAL MIN
When BATT:MODE set to CR mode, then
BATT:VAL 0.5
BATT:VAL 500mΩ
BATT:VAL MAX
BATT:VAL MIN
When BATT:MODE set to CP mode, then
BATT:VAL 0.5
BATT:VAL 500mW
BATT:VAL MAX
BATT:VAL MIN
[ADVance:]BATTery:VALue?[<space><MAX | MIN>]
BATT:VAL?
BATT:VAL? MAX
BATT:VAL? MIN
Channel-Specific
Set rising slew rate of current in battery discharge mode.
[ADVance:]BATTery:RISE<space><NRf+>[suffix]
BATT:RISE 0.1
BATT:RISE 100mA/μs
BATT:RISE MAX
BATT:RISE MIN
[ADVance:]BATTery:RISE?[<space><MAX | MIN>]
BATT:RISE?
BATT:RISE? MAX
BATT:RISE? MIN
Channel-Specific
Set falling slew rate of current in battery discharge mode.
[ADVance:]BATTery:FALL<space><NRf+>[suffix]
BATT:FALL 0.1
BATT:FALL 100mA/μs
BATT:FALL MAX
BATT:FALL MIN
[ADVance:]BATTery:FALL?[<space><MAX | MIN>]
BATT:FALL?
BATT:FALL? MAX
BATT:FALL? MIN
Channel-Specific
Set end voltage for battery discharge mode.
[ADVance:]BATTery:ENDVoltage<space><NRf+>[suffix]
Set current = minimum value.
Set resistance = 0.5Ω.
Set resistance = 0.5Ω.
Set resistance = maximum value.
Set resistance = minimum value.
Set power = 0.5W.
Set power = 0.5W.
Set power = maximum value.
Set power = minimum value.
Set slew rate = 0.1A/μs
Set slew rate = 0.1A/μs
Set slew rate = maximum value.
Set slew rate = minimum value.
Set slew rate = 0.1A/μs
Set slew rate = 0.1A/μs
Set slew rate = maximum value.
Set slew rate = minimum value.
Remote Operation
4-27