Chroma 63200A Series Operation & Programming Manual page 101

High Power Electronic Load 63200A Series Operation & Programming Manual
[ADVance:]IMPedance:STATic:RL
Type:
Description:
Setting Syntax:
Setting Parameters:For valid value range refer to respective specification.
Setting Example:
Query Syntax:
Return Parameters:<NR2>, [Unit = OHM]
Query Example:
[ADVance:]USER:WAVeform:NSELect
Type:
Description:
Setting Syntax:
Setting Parameters:<NRf+>, 1 ~ 10, Resolution = 1, Unit = None
Setting Example:
Query Syntax:
Return Parameters:<NR1>, [Unit = None]
Query Example:
[ADVance:]USER:WAVeform:DATA
Type:
Description:
Setting Syntax:
[ADVance:]USER:WAVeform:DATA<space><Arg1>,<Arg2>,<Arg3>,<Arg4>,<Arg5>
Setting Parameters:
Setting Example:
Query Syntax:
[ADVance:]USER:WAVeform:DATA?<space><NR1>[<space><MAX | MIN>]
4-38
Channel-Specific
Set the equivalent parallel load resistance for constant impedance
mode.
[ADVance:]IMPedance:STATic:RL<space><NRf+>[suffix]
IMP:STAT:RL 20
IMP:STAT:RL 10 OHM
IMP:STAT:RL MAX
IMP:STAT:RL MIN
[ADVance:]IMPedance:STATic:RL?[<space><MAX | MIN>]
IMP:STAT:RL?
IMP:STAT:RL? MAX
IMP:STAT:RL? MIN
Channel-Specific
Set the active waveform to run for user-define waveform function.
[ADVance:]USER:WAVeform:NSELect<space><NRf+>
USER:WAV:NSEL 5
USER:WAV:NSEL MAX
ADV:USER:WAV:NSEL MIN
[ADVance:]USER:WAVeform:NSELect?[<space><MAX | MIN>]
USER:WAV:NSEL?
ADV:USER:WAV:NSEL? MAX
ADV:USER:WAV:NSEL? MIN
Channel-Specific
Set the user-define waveform parameters. (Note: All setting
parameters in this command can't use suffix.)
Selects a waveform to be configured:
Arg1: <NR1>, 1 ~ 10, Resolution = 1, Unit = None.
Set the interval of waveform:
Arg2: <NRf>, 0.00001s ~ 20s, Resolution = 0.00001s, Unit =
Second
Set the repeat time of waveform:
Arg3: <NR1>, 0 ~ 100000, Resolution = 1, Unit = None.
Set the chain parameter of waveform:
Arg4: <NR1>, 0 ~ 10, Resolution = 1, Unit = None.
Set the interpolation function of waveform:
Arg5: <NRf>, NO(0), YES(1), Unit = None.
USER:WAV:DATA 1,0.001,1,0,YES
Set resistance = 20Ω.
Set resistance = 10Ω.
Set resistance = maximum value.
Set resistance = minimum value.
Set active waveform = 5
Set active waveform = maximum
value.
Set active waveform = minimum
value.