Table of Contents
Advertisement
High Power Electronic Load 63200A Series Operation & Programming Manual
See section 3.5.6 Setting Remote Communication Interface for the parameter settings of
GPIB communication interface.
3.3.5
USB Remote Control
The Universal Serial Bus (USB) port on the rear panel is a 4-pin USB connector that can be
used to connect the remote controller or PC for remote control.
3.4
Local/Remote Control
Local (front panel) control effects right after the device is powered on. The keys and display
on the front panel can be operated manually. The remote control begins when the 63200A
Series Electronic Load receives commands via GPIB / USB interface. Only the PC/Remote
Controller can control the Load when remote control is in effect. The front panel keys are all
invalid except LOCAL key. The user can press LOCAL to return to local control mode.
The detailed descriptions of basic remote programming are listed in Chapter4.
3.5
Configure
C H O I C E = 1
1 .
L O A D
2 . M E A S U R E M E N T
3 . P A R A L L E L / S Y N C .
4 . G O / N G
5 . P R O T E C T I O N
6 . R E M O T E
Main function setup description:
Main Function
Load Setup
Measurement
Parallel & Sync. Setup for parallel & sync. functions.
Configure
GO/NG Spec
Protection
Remote
System Setup
3-8
S E T U P
S P E C .
Setup for loading parameters.
Setup for measurement parameters.
Setup for spec inspection parameters.
Setup for current, power protection parameters.
Setup for communication interface.
Setup for system functions.
7 . S Y S T E M
S E T U P
Description
[ C O N F I G . ]
Refer to
3.5.1
3.5.2
3.5.3
3.5.4
3.5.5
3.5.6
3.5.7
Advertisement
Table of Contents
