Table of Contents
Advertisement
Type of Measurements
Voltage Measurements
Voltage measurements include 15 kinds of voltage parameter measurements.
1. Pk-Pk: Difference between maximum and minimum data values.
2. Max: Highest value in input waveform.
3. Min: Lowest value in input waveform.
4. Ampl: Difference between top and base in a bimodal signal, or between max and min
in an unimodal signal.
5. Top: Value of most probable higher state in a bimodal waveform.
6. Base: Value of most probable lower state in a bimodal waveform.
7. Cmean: Average of data values in the first cycle.
8. Mean: Average of all data values
9. Stdev: Standard deviation of all data values
10. Cstd: Standard deviation of all data values in the first cycle
11. Rms: Root mean square of all data values.
12. Crms: Root mean square of all data values in the first cycle.
13. Overshoot: Overshoot is distortion that follows a major edge transition expressed as
a percentage of Amplitude. ROV means rising edge overshoot and FOV means falling
edge overshoot.
Figure 65 Voltage Measurements
User Manual 131
Advertisement
Table of Contents
