Unpacking And Inspection - Teledyne VISION G2 CLASSIC 6 User Manual

Vision G2 Testers User Guide—74-108-800 Rev. H—12 June 2019

Unpacking and Inspection

This section provides instructions on unpacking and setting up
the Vision G2 dissolution tester.
NOTE: Moving, lifting, and carrying THR dissolution testers
requires 2 people to prevent damage to the instrument. Lift the
instrument by the frame below the vessel plate while supporting
the back of the tester to prevent it from tipping. DO NOT lift the
instrument by the chrome handle.
Unpack the Vision tester from the shipping container.
a. Note any damage to the shipping container. If
container is damaged, contact Teledyne
Hanson Research immediately.
b. Place shipping container near installation
location.
c. Remove straps from the container.
d. Open container and remove any accessory
boxes.
e. Carefully remove the Vision tester from the
shipping container. Remove protective bag
and cut the strap holding the support block.
Place the Vision tester on the bench.
f. The Vision tester should be placed at a 90°
angle from the desired operating position to
allow access to the back of the tester during
installation. Once the installation is complete,
the Vision tester can be placed in its final
position.
Installation
25 of 158