Internal Save And Recall - Teledyne T3DSO1000A Series User Manual

Internal Save and Recall

Internal save and recall supports Setups in Save/Recall. In the following part, the save
and recall method and procedures are introduced.
➢
Save the specified oscilloscope setting in internal memory.
1. Connect the signal to the oscilloscope and obtain a stable display.
2. Press Save/Recall button on the front panel to enter the SAVE/RECALL function
menu.
3. Press the Type softkey and then turn the Universal Knob to select Setups; and
then press the knob to confirm.
4. Press the Save To softkey to select Internal to save the current setup of the
oscilloscope to the internal memory.
5. Press the Setup softkey button; and then turn the Universal Knob to select the
location to save. The internal memory can save as many as 20 setup files, from
No.1～No.20.
6. Press the Save softkey to save the current setup to the appointed location. After a
few seconds the message "Store Data success!" will appear.
➢
Load the specified type of file to internal memory.
If you want to recall the setup after having finished the steps above, please do the
following steps:
Press the Setup softkey, and then turn the Universal Knob to select the location that
you want to recall, press the Recall softkey to recall the setup, and it will pop-up the
message "Read Data Success!"
Note: if you need to delete a setup file in the memory, please save a new setup to the
same location to overwrite it.
User Manual 147