Table of Contents
Advertisement
Automatic Measurements
Perform the steps below and select voltage or time parameters to make automatic
measurements.
1. Press the Measure button on the front panel to enter the MEASURE function menu.
The frequency and period will be enabled on the current trigger channel along with
the statistics.
2. Press the Source softkey, and then use the Universal Knob to select the desired
channel. Only analog channels that are displayed are available for measurements.
3. To select and display measurement parameters. Press the Type softkey, and then
turn the Universal Knob to select the desired measurement parameter.
4. Press the Universal Knob to add the measurement parameter, the parameters and
value will be shown above the menu, and the statistics status will update.
5. To turn off the statistic function, press the Statistics softkey to select Off.
The measurement display area can display 4 measurement parameters at most, and the
measurements will display according to the selecting order. If a fifth measurement
Parameter is added, the first measurement parameter will be deleted (FIFO).
Figure 69 Select the Measurement Parameter
User Manual 135
Advertisement
Table of Contents
