Connections And Setup; Electrical Connections; Connecting Power - Teledyne T700 Operation Manual

Getting Started

3.3. CONNECTIONS AND SETUP

3.3.1. ELECTRICAL CONNECTIONS

Note

3.3.1.1. Connecting Power

DO NOT LOOK AT THE PHOTOMETER UV LAMP; UV LIGHT CAN CAUSE EYE
DAMAGE.
ALWAYS WEAR GLASSES MADE FROM SAFETY UV FILTERING GLASS
(PLASTIC GLASSES ARE INADEQUATE).
Note
40
This section presents the electrical (Section 3.3.1) and pneumatic (Section 3.3.2)
connections for setup and preparing for instrument operation.
To maintain compliance with EMC standards, it is required that the cable
length be no greater than 3 meters for all I/O connections, which include
Analog In, Analog Out, Status Out, Control In, Ethernet/LAN, USB, RS-232,
and RS-485.
Attach the power cord to the calibrator and plug it into a power outlet capable of
carrying at least 10 A current at your AC voltage and that it is equipped with a
functioning earth ground.
WARNING – ELECTRICAL SHOCK HAZARD
 HIGH VOLTAGES ARE PRESENT INSIDE THE CALIBRATORS CASE.
 POWER CONNECTION MUST HAVE FUNCTIONING GROUND CONNECTION.
 DO NOT DEFEAT THE GROUND WIRE ON POWER PLUG.
 TURN OFF CALIBRATOR POWER BEFORE DISCONNECTING OR
CONNECTING ELECTRICAL SUBASSEMBLIES.
 DO NOT OPERATE WITH COVER OFF.
CAUTION – AVOID PERSONAL INJURY
The T700 calibrator is equipped with a universal power supply that allows
it to accept any AC power configuration, within the limits specified in
Table 2-2.
Teledyne API – Model T700 Dynamic Dilution Calibrator
06873B DCN6388