Table of Contents
Advertisement
To Enable the Channel
The oscilloscope provides 2 or 4 analog input channels and provides independent vertical
controls for each channel. This chapter takes CH1 as an example since all of the vertical
channel setting methods are the same for all other channels.
Connect a signal to the CH1 channel BNC connector; and then press the CH1 button in
the vertical control area (VERTICAL) on the front panel to enable CH1 and illuminate the
CH1 button.
The channel setting menu is displayed at the bottom of the screen and the channel label
at the right side of the screen. The information displayed in the channel label is related to
the current channel setting.
After the channel is turned on, modify the parameters such as the vertical scale, the
horizontal time base and the trigger mode according to the input signal to make the
waveform display easy to observe and measure.
Note: to turn off the channel, press the channel button until
the channel indication light is no longer illuminated.
26 User Manual
Advertisement
Table of Contents
