Pattern Trigger - Teledyne T3DSO1000A Series User Manual

Digital oscilloscope
Table of Contents

Advertisement

Pattern Trigger

The Pattern trigger identifies a trigger condition by looking for a specified pattern. The
pattern trigger can be expanded to incorporate delays similar to other triggers. Pattern
durations are evaluated using a timer. The timer starts on the last edge that makes the
pattern "true". Potential triggers occur on the first edge that makes the pattern false,
provided that the time qualifier criterion has been met.
patterns: logical AND, OR, NAND and NOR combination of the channels. Each channel
can be set to low, high or invalid.
Trigger position 1
Do the following steps to set pattern trigger:
1. Press the Setup button on the front panel to enter the TRIGGER function menu.
2. Press the Type softkey; turn the Universal Knob to select Pattern, and then push
down the knob to confirm.
3. Press each channel softkey to select Invalid, High or Low.
Low sets the pattern to low on the selected channel. A low is a voltage level that
is less than the channel's trigger level or threshold level.
High sets the pattern to high on the selected channel. A high is a voltage level
that is greater than the channel's trigger level or threshold level.
Invalid sets the pattern to invalid on the selected channel. Any channel set to
invalid is ignored and is not used as part of the pattern.
However, if all channels in the pattern are set to Invalid, the oscilloscope will not
trigger.
Adjust the trigger level for the selected analog channel by turning the Trigger
Level knob. Invalid doesn't need to set a trigger level.
4. Press the Next Page softkey to enter the second page of the pattern trigger menu.
5. Press the Logic softkey and then turn the Universal Knob to select the desired logic
combination AND, OR, NAND or NOR.
6. Press the Time softkey; then turn the Universal Knob to select the desired time
value.
7. Press the Holdoff Close softkey to turn on the Holdoff function; then turn the
Channel 1High
Channel 2 Low
AND Waveform
Trigger position 2
provides 4
The oscilloscope
User Manual 79

Advertisement

Table of Contents
loading

This manual is also suitable for:

T3dso1000 seriesT3dso1102T3dso1204T3dso1104

Table of Contents