Table of Contents
Advertisement
To Set the WLAN (Op�on)
The T3DSO1000 series support an external USB WIFI adapter. This option is not available
on the T3DSO1102. Do the following steps to set the oscilloscope to communicate with a
PC via WLAN:
1. Connect the oscilloscope USB Host to your wireless network adapter, and make sure
your local wireless network is enabled.
2. Press the Utility button on the front panel to enter the UTILITY function menu.
3. Press the IO Set softkey to enter the I/O SET function menu.
4. Press the Net Interface softkey, then select WLAN.
5. Press the WiFi Set softkey to enter the WiFi set interface.
6. Press the WiFi Operation softkey to turn on or turn off the WIFI setup menu.
Off: the WIFI setup menu is off
On: you can set the SSID and PSK manually.
➢ Manual Scan: press this softkey, the oscilloscope will search the network
automatically. Turn the Universal Knob to select a network; then press the
Universal Knob to confirm.
➢ SSID: press this softkey, a dialogue box will pop up, enter your SSID then
press Confirm.
➢ PSK: press this softkey, a dialogue box will pop up, enter your SSID then
press Confirm.
➢
Connect: press this softkey to connect to the wireless network.
7. Press Connect softkey when your SSID and PSK configuration are finished.
8. Return to the I/O SET menu
"To Set the LAN")
9.
Use NI Visa to communicate with the oscilloscope.
Figure 96 WIFI settings menu
Press the IP Set softkey to finish the IP configuration (see
.
User Manual 177
Advertisement
Table of Contents
