Table of Contents
Advertisement
LED Test
LED test is used to test the button lights.
1. Press the Utility button on the front panel to enter the UTILITY function menu.
2. Press the Next Page softkey to go to the second page of the UTILITY function menu.
3. Press the Next Page softkey to go to the third page of the UTILITY function menu.
4. Press the Do Self Test softkey to enter the SELFTEST function menu.
5. Press the LED Test softkey to enter the keyboard test interface, as the picture shown
below.
6. Use the information displayed on the screen to test the LEDs: press the Single button
continually to light the button lights one at a time. The Run/Stop button displays red
the first time the Single Button is pressed. On the second press the Run/Stop button
displays green. Then the other button lights will be lit one by one. On the last press all
of the buttons will be lit at the same time.
7. Press the Run/Stop button to exit the LED test program.
Figure 100 LED Test
User Manual 183
Advertisement
Table of Contents
