To Update Firmware And Configuration - Teledyne T3DSO1000A Series User Manual

To Update Firmware and Configuration

The firmware and configuration can be updated directly via USB flash drive.
Do the following steps to update the firmware:
1. Insert the USB flash drive which contains the firmware and the configure files into
the USB host interface on the front panel of the oscilloscope.
2. Press the Utility button on the front panel to enter the UTILITY function menu.
3. Press the Next Page softkey to go to the second page of the UTILITY function menu.
4. Press the Next Page softkey to go to the third page of the UTILITY function menu.
5. Press the Update softkey to enter the UPDATE function menu.
6. Press the Firmware softkey and the message "Press "Single" to continue and
Press "Run/Stop" to exit!
7. Press the Single button to enter the SAVE/RECALL file system.
8. Turn the Universal Knob to select the update file which should be with an ADS postfix,
and then press the Load softkey to start the firmware update. The process needs about
7 minutes. And during the update, do not turn off the oscilloscope or disconnect the
oscilloscope power, otherwise the oscilloscope will not start again.
9. After the update has finished, the screen will display the message "Update success,
please restart the DSO", and the oscilloscope buzzer will sound.
10. Restart the oscilloscope to finish the firmware update.
Do the following steps to update the configuration:
1. Insert the USB flash drive which contains the firmware and the configure files into
the USB host interface on the front panel of the oscilloscope.
2. Press the Utility button on the front panel to enter the UTILITY function menu.
3. Press the Next Page softkey to go to the second page of the UTILITY function menu.
4. Press the Next Page softkey to go to the third page of the UTILITY function menu.
5. Press the Update softkey to enter the UPDATE function menu.
6. Press the Configure softkey to enter the SAVE/RECALL file system.
7. Turn the Universal Knob to select the update file which will have a CFG postfix,
and then press the Load softkey to start updating the firmware. The process
needs about 30 seconds.
8. After the update has finished, the screen will display the message "Update success,
Please restart the DSO", and the oscilloscope buzzer will sound.
9. Restart the oscilloscope to finish the configuration update.
180 User Manual