Table of Contents
Advertisement
CHAPTER 4 PARAMETER
4
PA2_31 to 34 Point detection, area detection settings
No.
Point detection, area
31
detection
Point detection, area
32
detection position 1
Point detection, area
33
detection position 2
34
Point detection range
This parameter is enabled only for LS type.
Specify the output format of the "point detection, area detection" signal that is output as an output
signal (OUT signal).
In case of point detection setting, the signal is output if the servomotor is located nearly in the reference
value (point detection range).
In case of area setting, the signal is turned on or off if the servomotor position exceeds the reference
value. Refer to the chart below.
4-76
Automatic Operation Setting Parameters
Name
0: Point detection
1: ON for positive side
2: ON for negative side
-2000000000 to 2000000000 [unit amount]
-2000000000 to 2000000000 [unit amount]
0 to 2000000000 [unit amount]
Setting range
Default
Change
value
0
Always
0
Always
0
Always
100
Always
Advertisement
Table of Contents
