Over Write Completion: Sequence Output Signal (Reference Value 13); Read Completion: Sequence Output Signal (Reference Value -); Write Command: Sequence Input Signal (Reference Value -); Read Command: Sequence Input Signal (Reference Value -) - Fuji Electric ALPHA7 User Manual

Over write completion: Sequence output signal (Reference value 13)

Read completion: Sequence output signal (Reference value -)

Write command: Sequence input signal (Reference value -)

Read command: Sequence input signal (Reference value -)

Signals used to execute read/wirte parameters and positionind data in IQ area.
 Function
(1) Parameter overwrite
Select a parameter type in the data selection area.
A parameter is overwritten with the activation of overwrite command (-) according to the table
below. When the write command is turned off, the over write completion (13) is also turned off.
Switching PA1_nn, PA2_nn, PA3_nn, or PA4_nn
Parameter settings
Parameter no.
Write command
Over write completion
(Parameter)
You can change parameter reference values when the over write completion signal has been
turned on.
(2) Parameter read
Select a parameter type in the data selection area.
A parameter is loaded with the activation of read command according to the table below.
When the read command is turned off, the read completion is also turned off.
Switching PA1_nn, PA2_nn, or PA3_nn
Parameter settings
Parameter no.
Read command
Read completion
(Parameter)
The loaded parameter data is established when the read completion signal has been turned
on.
Name
OFF
OFF
Name
OFF
OFF
CHAPTER 2 WIRING
bit 8 to 11 position in %QW＊.14
%QD＊.8
Low order byte in %QW＊.14
ON
ON
Area
bit 8 to 11 position in %QW＊.14
(%QD＊.0)
Low order byte in %QW＊.14
ON
ON
Description of I/O Signals
Area
2-83
2