Md0: Sequence Output Signal (Reference Value 60); Md1: Sequence Output Signal (Reference Value 61); Md2: Sequence Output Signal (Reference Value 62); Md3: Sequence Output Signal (Reference Value 63) - Fuji Electric ALPHA7 User Manual

CHAPTER 2 WIRING

MD0: Sequence output signal (Reference value 60)

MD1: Sequence output signal (Reference value 61)

MD2: Sequence output signal (Reference value 62)

MD3: Sequence output signal (Reference value 63)

2

MD4: Sequence output signal (Reference value 64)

MD5: Sequence output signal (Reference value 65)

MD6: Sequence output signal (Reference value 66)

MD7: Sequence output signal (Reference value 67)

The M code of positioning data currently executed is output.
This signal is enabled only for LS type.
 Function
Positioning data M codes are output as is during execution.
Unlike JIS B 3614, there are no specific functions for M00, M02, M30, M98, or M99, and all codes
output are general-purpose codes.
There are no interlock functions such as MON or MOFF.
M codes are hexadecimal from 00 to FFH.
The default value M code output value is FFH (MD0 to MD are all ON).
 Parameter setting
If assigning MD0 to the IQ area (sequence output terminal), set the value (60) corresponding to
the output terminal function setting parameter. The IQ area already has an M code area.
2-104
Description of I/O Signals