Table of Contents
Advertisement
■ Precautions on installation
Do not ride on the servomotor or place a heavy matter on it.
It might cause failure, breakage, electric shock and injuries.
Do not block the exhaust port or do not allow foreign substance to enter.
It might cause fire and electric shock.
Observe the installation orientation of the servo amplifier.
Otherwise, it might cause fire and failure.
Do not apply strong impact.
It might cause failure.
The shaft-through hole of the servomotor is not water proof or oil proof. Take measures on the
machine side to block entry of water, coolant or similar from entering inside the servomotor.
It might cause failure.
If case of application when massive water or oil is splashed on the main body of the servomotor,
install a water or oil splash guard or take similar measures on the machine side.
In a humid and high oil mist environment, install the lead wires and connectors in a face down
orientation.
It might cause poor insulation, short circuit and resultant failure.
Never remodel the servomotor and servo amplifier.
It might cause fire and failure. It will not be covered by the warranty.
Do not apply strong impact on the output shaft of the servomotor.
It might cause damage to the encoder inside the motor.
CHAPTER 0 INTRODUCTION
CAUTION
Do not disassemble
Do not hammer
0-5
Safety Precautions
0
Advertisement
Table of Contents
