Table of Contents
Advertisement
Connecting to Other Devices/Systems
Make all desired cable connections. After start up, configure the connections using the menu options
listed below. More detailed instructions are provided later in this manual.
LAN
The instrument accepts DHCP network addressing. Connect a cable from the Ethernet port on the
side panel to a network access device.
To assign a static IP address, go to Utilities > Utilities Setup > Remote and choose Net Connections
from the Remote dialog. Use the standard Windows networking dialogs to configure the device
address.
Go to Utilities > Preference Setup > Email to
USB Peripherals
Connect the device to a USB port on the front or side of the instrument.
Printer
The HDO9000 supports USB printers compatible with the instrument's Windows OS. Go to Utilities >
Utilities Setup > Hardcopy to
External Monitor
You may operate the instrument using the built-in touch screen or attach an external monitor for
extended desktop operation. A properly configured external touch-screen monitor will take on all the
touch-screen capabilities of the internal display.
Note: The oscilloscope display utilizes Fujitsu touch-screen drivers. Because of conflicts,
external monitors with Fujitsu drivers can not be used to control the system, only as displays.
The HDO9000 supports WQXGA monitors with 2560x1600 resolution.
Connect the monitor cable to the DisplayPort connector on the side of the instrument (you can use an
adaptor if the monitor cable has a different interface). Monitors with DVI-D interfaces are also
supported. Minimize the X-Stream application and use the Windows controls to configure the display.
Configure the instrument as the primary monitor and be sure to extend, not duplicate, the display.
Remote Control
Go to Utilities > Preference Setup > Remote to
the cable type required by your selection. TCP/IP over Ethernet is generally supported, as is USB over
the USBTMC connection. GPIB is also supported with the correct hardware option installed.
configure email
configure printer
settings.
configure remote
Oscilloscope Set Up
settings.
control. Connect the devices using
13
Advertisement
Table of Contents
