Table 5-3: Lan/Internet Configuration Properties - Teledyne T700 Operation Manual

Communications Setup and Operation

Table 5-3: LAN/Internet Configuration Properties

PROPERTY DEFAULT
STATE
DHCP STATUS
INSTRUMENT
IP ADDRESS
GATEWAY IP
ADDRESS
SUBNET MASK
1
TCP PORT
HOST NAME
1
Do not change the setting for this property unless instructed to by Teledyne API's Customer Service
personnel.
Note
182
This displays whether the DHCP is turned ON or OFF.
On
This string of four packets of 1 to 3 numbers each (e.g. 192.168.76.55.)
0.0.0.0
is the address of the calibrator itself.
A string of numbers very similar to the Instrument IP address (e.g.
0.0.0.0 192.168.76.1.) that is the address of the computer used by your LAN to
access the Internet.
Also, a string of four packets of 1 to 3 numbers each (e.g.
255.255.252.0) that defines that identifies the LAN to which the device is
connected.
0.0.0.0
All addressable devices and computers on a LAN must have the same
subnet mask. Any transmissions sent devices with different subnet
masks are assumed to be outside of the LAN and are routed through a
different gateway computer onto the Internet.
This number defines the terminal control port by which the instrument is
3000 addressed by terminal emulation software, such as Internet or Teledyne
API's APICOM.
The name by which your calibrator will appear when addressed from
other computers on the LAN or via the Internet. While the default setting
T700
for all Teledyne API's T700 calibrators is "T700", the host name may be
changed to fit customer needs.
If the gateway IP, instrument IP and the subnet mask are all zeroes (e.g.
"0.0.0.0"), the DCHP was not successful in which case you may have to
configure the calibrator's Ethernet properties manually. See your network
administrator.
Teledyne API – Model T700 Dynamic Dilution Calibrator
DESCRIPTION
06873B DCN6388