Table of Contents
Advertisement
I. Clear and restart the statistics. Pressing the Clear Sweeps button on the front panel has
an equivalent effect
J. Set the time gate for measurement
18.2 Set Parameters
Touch Type in the measure dialog box, or touch + in the measurement parameters
and statistics display area to open the parameter selection window:
A. Set the source of the current setting.
B. Measurement parameter classification tabs, including Favorite, Vertical, Horizontal,
Miscellaneous and CH Delay. Touch a tab and in the area will display the
corresponding parameters
C. Parameters. Touch the parameter to be measured to activate it, and touch it again to
close the parameter.
D. Background highlighted parameters represent it is activated. In the figure above, "Pk-
Pk" and "ROV" are activated.
E. Description of the last selected parameter.
The correct steps to add a measurement parameter are to select the source in the area
and then select the parameter in the area. For example, to add Pk-Pk measurements for
C1 and Period measurements for C2, follow the steps below:
Source>C1>Vertical>Pk-Pk
Source>C2>Horizontal>Period
1.800.561.8187
www.
.com
information@itm.com
T3DSO2000A Manual. Page 108
Advertisement
Table of Contents
