16
. BRAKE SYSTEM
BRAKE MASTER CYLINDERS
REMOVAL / INSTALLATION
REMOVAL
Front/rear master cylinder
Remove the brake reservoir cap and drain
the brake fluid from the hydraulic brake
system
*
Do not splash brake fluid onto any
rubber, plastic and coated parts. When
working with brake fluid, use shop
towels to cover these parts.
Remove the bolt/nut and then remove the
brake lever.
Remove fluid hose bolt/two washers and
then disconnect the fluid hose.
*
When removing the brake fluid hose
bolt, be sure to place towels under the
hose and plug the hose end to avoid
brake fluid leakage and contamination.
Remove the two master cylinder holder
bolts .and rear stop switch spring remove
the master cylinder.
16-27
Cap
Drain Brake Fluid
Bolt
UXV 500
Reservoir