KYMCO UXV 500i Service Manual page 314

16
. BRAKE SYSTEM
Connect a transparent hose to the right
caliper bleed valve and then loosen the
bleed valve nuts.
Use the syringe to draw brake fluid into it
until there is no air bubbles in the
transparent hose.
Then, tighten the bleed valve nut.
Torque: 0.6 kgf-m (6 Nm, 4.32 lbf-ft)
Connect a transparent hose to the left
caliper bleed valve and then loosen the
bleed valve nuts.
Use the syringe to draw brake fluid into it
until there is no air bubbles in the
transparent hose.
Then, tighten the bleed valve nut.
Torque: 0.6 kgf-m (6 Nm, 4.32 lbf-ft)
＊
• When drawing brake fluid with the
syringe, the brake fluid level should be
kept over 1/2 of the brake reservoir
height.
• Use only the recommended brake fluid.
Recommended Brake Fluid: DOT-4
16-11
UXV 500