Table of Contents
Advertisement
16
. BRAKE SYSTEM
UXV 500
A wear indicator is provided on each brake.
The indicators allows checking of brake
pads wear. Check the position of the
indicator.
Install the new brake pads.
Install the brake pad mounting pins.
Install the brake caliper mounting bolts to
the specified torque.
Torque: 2.7 kgf-m (27 Nm, 19.5 lbf-ft)
Tighten the brake pad mounting pins.
Torque: 1.8 kgf-m (18 Nm, 13 lbf-ft)
REAR BRAKE PADS
Remove the rear wheel. ( refer to the
" REAR WHEEL
REMOVAL/INSPECTION/
INSTALLATION " section in the chapter
15 ).
16-4
Advertisement
Chapters
Table of Contents
Troubleshooting
