KYMCO UXV 500i Service Manual page 130

7. ENGINE REMOVAL/INSTALLATION
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• A floor jack or other adjustable support is required to support and maneuver the engine.
Be careful not to damage the machine body, cables and wires during engine removal.
• Use shop towels to protect the machine body during engine removal.
• The following components require engine removal for serviced with the engine installed in the
frame.
™ Oil pump (Chapter 4)
™ Water pump (Chapter 6)
™ Cylinder head (Chapter 8)
™ Cylinder/Piston (Chapter 9)
™ Drive and driven pulleys/clutch (Chapter 10)
™ Alternator/Starter clutch (Chapter 17 and 19)
• The following components require engine removal for service.
™ Transmission (Chapter 11)
™ Crankshaft/Crankcase/Balance shaft (Chapter 12)
TORQUE VALUES
Engine mounting bolt/nut
Engine hanger nut
Front propeller shaft bolt
7-1
6 kgf-m (60 N-m, 43.5 lbf-ft)
3.5 kgf-m (35 N-m, 25 lbf-ft)
4.5 kgf-m (45 N-m, 32.5 lbf-ft)
UXV 500