KYMCO UXV 500i Service Manual page 411

22. FUEL INJECTION SYSTEM
UXV 500i
TPS INSPECTION
Support the ATV on a level surface.
Turn the ignition switch to "ON".
Measure if the ECU voltage outputs to TPS
between the following terminals of the TPS
connector.
Terminal Normal
V/R (+) -V/G(-) 5 V
Throttle position sensor (TPS) resistance
(at 20°C/68°F) 3500~6500Ω
Adjusting Nuts
REMOVAL
Loosen the throttle cables with the adjusting
nuts.
Disconnect the throttle cable ends from
throttle seat.
Cable Ends
TPS Sensor T-MAP Sensor
Disconnect the TPS, ISC and T- MAP
sensor connectors.
Loosen the air cleaner connecting hose band
screw.
Loosen the intake manifold band screw.
Remove the throttle body, T-MAP sensor,
TPS sensor and ISC sensor as a set.
ISC
22-26