KYMCO UXV 500i Service Manual page 302

15.
REAR WHEEL/SHOCK
ABSORBER/SWING ARM
ASSEMBLY
Apply lightweight lithium-soap base grease
to the new bearings of the steering knuckle
and lips of the new dust seal before install
them.
Install the new inner bearing by using the
special tool.
Special tool:
Oil seal and bearing driver
Install the spacer into the steering knuckle.
＊
Make sure the long side of the spacer
faces the outer bearing
Install the new outer bearing by using the
special tool.
Special tool:
Oil seal and bearing driver
Install the new dust seals by using the
special tool.
Special tool:
Oil seal and bearing driver
15-11
A120E00014
Bearing Driver
A120E00014
A120E00014
Bearing Driver
UXV 500
Duct Seal