13
. DRIVE TRAIN
Inspect the free play by using a push-and-
pull motion (thrust movement).
Excessive play → Replace the joint
assembly.
INSTALLATION
Install a new circlip into its groove in the
splines.
Apply lightweight lithium-soap base grease
to the splines of the drive shafts and install
the cvj to the front assy gearcase.
*
● Be careful not to damage the oil seal
in the front assy gear case.
● After installing cvj, check the circlip is
seated properly by pulling the case
side joint lightly.
Circlip
Case Side Joint
UXV 500
13-4