Installation - KYMCO UXV 500i Service Manual

Hide thumbs Also See for UXV 500i:

Table of Contents

FRONT WHEEL/FRONT SUSPENSION/

STEERING SYSTEM

INSTALLATION

Install the wheel hub, washer and nut.

Apply grease onto the wheel hub splines.

Apply the front brake and then tighten the

nut to the specified torque.

Torque: 20 kgf-m (200 N-m, 145 lbf-ft)

Install the cotter pin and band ends of cotter

● Do not apply oil to the seat of the nut.

● Do not loosen the wheel hub nut after

torque tightening. If the wheel hub nut

groove is not aligned with the cotter

pin hole, align groove with the hole by

tightening up on the wheel hub nut.

Always use a new cotter pin.

Table of Contents