Wts Sensor - KYMCO UXV 500i Service Manual

22. FUEL INJECTION SYSTEM
UXV 500i
WTS SENSOR (Water
Temperature Sensor)
REMOVAL / INSTALLATION
Drain the coolant from the cooling system.
Disconnect the WTS sensor connector from
the sensor.
Remove the WTS sensor and O-ring.
Install a new O-ring and WTS sensor.
＊
Always replace an O-ring with a new one.
Tighten the WTS sensor to the specified
torque.
Torque: 1.2 kgf-m (12 N-m, 8.6 lbf-ft)
Connect the WTS sensor connector.
Fill the cooling system with the
recommended coolant.
O-ring
INSPECTION
Measure the resistance at the WTS sensor
terminals.
STANDARD
ºC -20 40 100
KΩ 28.6 1.46 0.176
Standard: 3.51±10% KΩ (at 20°C/68°F)
22-24