KYMCO UXV 500i Service Manual page 379

20. LIGHTS/SWITCHES
GEAR INDICATOR LIGHT
SWITCHES
INSPECTION
Disconnect the gear indicator light switch
wire connector.
Check for continuity between the switch
side connector terminal and engine ground.
REPLACEMENT
Disconnect the gear indicator light switch
connector.
Remove the bolt, then remove the gear
indicator light switch and washer.
Install the washer and a new switch with a
new O-ring (apply engine oil to O-ring).
＊
Make sure that the lever on the gear
indicator light switch correctly engages
with the locating slot on the shift shaft.
Shift the drive select lever to check if the
gear indicator light is correct.
Gear
Gear Indicator Light Switch
Gear Indicator Light Switch Connector
O-ring Washer
UXU 500
20-6