1
. GENERAL INFORMATION
Tool Name
Driven pulley holder
(Refer to the "DRIVEN PULLEY
DISASSEMBLY/INSPECTION/
ASSEMBLY" section in the chapter
10.)
Flywheel puller
(Refer to the "STARTER
CLUTCH REMOVAL/
INSPECTION/
INSTALLATION" section in the
chapter 19.)
Oil filter cartridge wrench
(Refer to the "(Refer to the
"ENGINE OIL" section in the
chapter 3.)
Output shaft bearing nut
wrench
(Refer to the "(Refer to the
"BEARING REPLACEMENT
IN THE RIGHT
CRANKCASE" section in the
chapter 11.)
(Note: the special tools may differ
Tool No.
A120E00059
A120E00060
A120E00061
A120E00066
Illustration
slightly from those shown in the
figure of this manual.)
UXV 500
(Cont'd)
1-16