KYMCO UXV 500i Service Manual page 223

11
.FINAL REDUCTION/
TRANSMISSION SYSTEM
OUTPUT SHAFT FRONT/REAR
BEARING REPLACEMENT
＊
The output shaft bearings can be replaced
when the crankcase is assembly.
REAR SIDE BEARING
Remove the oil seal.
Remove the nut by using the special tool.
Special tool:
Nut wrench
Remove the bearing by using the special tool.
Special tool:
Bearing Puller
Install the new bearing.
A120E00066
A120E00037
Rear Side Bearing
Front Side Bearing
Oil Seal
Bearing Puller
UXV 500
Nut
Bearing
11-14