KYMCO UXV 500i Service Manual page 188

10. DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
Place a block on the plate nut.
Compress the spring by using a
commercially available puller, install the
drive belt.
＊
● The drive belt should be installed so
that the arrows on the drive belt
periphery point in the normal turning
direction.
● The drive belt contact surface of the
driven face should be thoroughly
cleaned.
Install the driven pulley assembly and drive
V-belt.
Use the special tool to hold driven pulley,
then tighten the nut to the specified torque.
Torque: 10 kgf-m (100 N-m, 72 lbf-ft)
Special tools:
Y-type holder
Apply lubricant to the drive face boss inner
surface, then install the drive pulley.
10-7
Apply oil to the threads
A120E00056
Block
Nut
Y-type Holder
Apply lubricant
Drive Face Boss
UXV 500