9. CYLINDER/PISTON
CYLINDER AND PISTON
REMOVAL/INSPECTION/
INSTALLATION
REMOVAL
Remove the cylinder head (refer to
"CYLINDER HEAD
REMOVAL/INSTALLATION" section in
the chapter 8).
Take the block pin out.
Remove the water hose from the cylinder.
Remove the two cylinder bolts/washers.
Remove the cylinder.
Remove the dowel pins and gasket.
Remove the piston pin clip.
*
Place a clean shop towel in the crankcase
to keep the piston pin clip from falling
into the crankcase.
Press the piston pin out of the piston and
remove the piston.
9-3
Cylinder
Gasket
Piston Pin Clip
Piston
UXV 500
Block Pin
Water Hose
Dowel Pins
Piston Pin