KYMCO UXV 500i Service Manual page 398

13. FUEL INJECTION SYSTEM
Blinks Failure
Fault description
Codes
Ignition coil or electric
circuit malfunction
11 P0350
Fuel pump relay or
12 P0230
electric circuit
malfunction
13 P0219 Engine speed is over
than top speed
14 P1560 Sensor don't receive
power source from ECU
15 P0700 Engine starting speed
exceed CVT speed
limited
Engine temperature
sensor or electric circuit
16 P0115
malfunction
17 P1561 Temperature gauge
electric circuit
malfunction
22-13
Priority
1. Check if the connector of ignition coil is loosen.
2. Check if the ECU send signal to Ignition coil.
3. Check if the power source and resistance is
malfunction
2
1. Check if the connector of relay is loosen.
2 2. Check if the ECU send signal to relay.
3. Check the fuel pump relay resistance
Check if the belt of CVT is broken.
2
.Check if ECU output DC5V to sensor.
2. Check if the power source of all sensor is DC5V.
3. Replace a new ECU if the CELP still blinks even the
2 output power source of ECU is normal.
Don't use it at present.
2
1. Check if the connector of sensor is loosen.
2. Check if ECU pin is broken.
3.Check if the resistance of sensor is malfunction.
2
Don't use it at present.
2
Fault management
UXV500i