Secondary Drive/Driven Bevel Gear - KYMCO UXV 500i Service Manual

11
.FINAL REDUCTION/
TRANSMISSION SYSTEM
SECONDARY DRIVE/DRIVEN
BEVEL GEAR
REMOVAL/INSPECTION/INSTAL
LATION
REMOVAL
Drain engine oil into a clean container. (Refer
to the "ENGINE OIL" section in the chapter
3).
Move the engine assembly forward (refer to
the "ENGINE REMOVAL" section in the
chapter 6) or remove the rear propeller (refer
to the "REAR PROPELLER SHAFT
DISASSEMBLY/INSPECTION/
ASSEMBLY" section in the chapter 13).
Remove the five bolts, then remove the bevel
gear case cover.
Remove the two dowel pins and gasket.
Using a chisel, unlock the nut in the rear
middle joint.
11-3
Bevel Gear Case Cover
Gasket
Rear Middle Joint
UXV 500
Dowel Pins