KYMCO UXV 500i Service Manual page 140

7. ENGINE REMOVAL/INSTALLATION
Install the rear cooling duct.
＊
Make sure the lug on the left crankshaft
case into the cutout on the rear cooling
duct.
Install the removed parts in the reverse
order of removal.
Route the water hoses, wire and cable
properly (refer to the "CABLE &
HARNESS ROUTING" section in the
chapter 1).
Adjusting the following items:
● Engine oil (refer to the "ENGINE OIL"
section in the chapter 3).
● Engine coolant (refer to the "COOLANT
REPLACEMENT" section in this
chapter).
7-11
UXV 500
Cooling Duct