KYMCO UXV 500i Service Manual page 405

22. FUEL INJECTION SYSTEM
ELECTRIC CONTROL UNIT
(ECU)
REMOVAL/INSTALLATION
＊
● Do not disconnect or connect the ECU
connector during the ignition switch
"ON"; it may cause the ECU damaged.
● The throttle position sensor (TPS) and
idle air bypass valve (ISC) have to be
reset when throttle body, MAP, TPS,
ISC or ECU has been reinstalled.
Disconnect the ECU connector and remove
the ECU from the frame.
Installation is in the reverse order of the
removal.
ECU connector remove procedure
(Same as DOWNTOWN 125i)
ECU connector install procedure
(Same as DOWNTOWN 125i)
ECU Connector
UXV 500i
22-20