KYMCO UXV 500i Service Manual page 224

11
.FINAL REDUCTION/
TRANSMISSION SYSTEM
Install and tighten the nut to the specified
torque by using the special tool.
Torque: 11 kgf-m (110 N-m, 79.2 lb-ft)
Special tool:
Nut wrench
Apply clean engine oil to the new oil seal lip
then install the oil seal.
FRONT SIDE BEARING
Remove the oil seal.
Remove the snap ring.
Remove the bearing by using the special tool.
Special tool:
Bearing Puller
Install the new bearing by using the special
tool.
Special tool:
Bearing driver
11-15
A120E00066
A120E00037
A120E00014
Oil Seal
Oil Seal
Bearing Puller
UXV 500
Nut
Snap Ring
Bearing Driver