10. DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
LEFT CRANKCASE COVER
REMOVAL/INSTALLATION
REMOVAL
REMOVAL CTV PARTS ON VEHICLE
Key Switch "OFF".
Remove the seat, and center cover. cargo
bed Up then remove the fuel cap.
Remove the side panel .R. front and
protector Fuel tank.
Remove the tank frame.
Disconnect the fuel tube from fuel pump.
Disconnect the fuel unit connectors.
Remove the 4 bolts and from the fuel tank,
then remove the fuel tank.
Remove the CVT cover bolts.
Disconnect the CVT cover.
Remove the CVT parts.
Remove the ten bolts, remove the left
crankcase cover and rubber gasket.
(refer to chapter 10-27)
Remove the two dowel pins.
INSTALLATION
Install the rubber gasket onto the left
crankcase cover.
Install the two dowel pins onto the left
crankcase cover.
10-3
CVT Cover
Dowel Pins
Dowel Pins
UXV 500
Bolts
Rubber Gasket