KYMCO UXV 500i Service Manual page 316

Hide thumbs Also See for UXV 500i:

Table of Contents

. BRAKE SYSTEM

REAR BRAKE FLUID

CHANGE/AIR BLEED

Brake fluid change

Place the machine on the level ground and

set the handlebar upright.

Remove the two screws from the brake fluid

reservoir cap.

Use shop towels to cover plastic parts

and coated surfaces to avoid damage

caused by splash of brake fluid.

Connect a transparent hose to the brake

caliper bleed valve and then loosen the

bleed valve nut.

Use a syringe to draw the brake fluid out

through the hose.

Fill the brake reservoir with brake fluid and

use the syringe to draw brake fluid into it

until there is no air bubbles in the

transparent hose.

Then, tighten the bleed valve nut.

Torque: 0.6 kgf-m (6 Nm, 4.32 lbf-ft)

• When drawing brake fluid with the

syringe, the brake fluid level should be

kept over 1/2 of the brake reservoir

• Use only the recommended brake fluid.

Recommended Brake Fluid: DOT-4

Chapters

Table of Contents